door hinge pins

[bmt336]

ok, the green fhp has the original door hinge pins on the pass door, which is sagging. How do you get the originals out so the replacements will go in? they seem to have been pressed in, can it be done without removing the entire door. The driver door had already had the bottom one done, so it was easy to replace.
Also put in new door to body weatherstrip today.

[ImEvil1]

They are pinned in there....kinda hard to remove, as you have to grind them down a bit to knock them out.

[bmt336]

so dremel tool is good?

[ImEvil1]

Air, if you have it. It's halfway-serious grinding.

[bmt336]

yea, Frank has a compressor in the shop. Thanks

[bmt336]

yea, this was the biggest pita of anything on this car. But it is done and the doors line up real well.

[ImEvil1]

You did it already? Good deal.

[svopaul]

You are already done but I just cut the pin in the middle and then remove both pieces...much easier than trying to get the whole pin out.