PDA

View Full Version : VACUUM Line Harness-Engine Bay

Winterpark SSP
10-30-2007, 04:06 PM
As I am replacing just about everything that is not 100%, my vacuum line harness near the plenum has very hard and brittle lines, Ford Part (# F3ZZ9E455A) has not been available since 2000.

Any suggestions on where to locate one?

THANK YOU!

Barry
TR1
10-30-2007, 06:47 PM
The one that bolts to the firewall? Did you check 5.0 resto?
Winterpark SSP
10-30-2007, 08:12 PM
Its a 4 wire (black, grey, green and red) set up that connects to what I believe are vacuum pump(s)?? located behind the passenger side strut. The 4 wires connect to a 4-prong adapter (male/female) and there are 2 grey and two black vacuum lines that connect to different parts of the motor.

I will try the website yo reccomend and get back to you. Thanks for everything!!!

Barry
Winterpark SSP
10-31-2007, 07:50 AM
No luck at 50 Resto , still cannot find one.
1990GSP
11-01-2007, 07:51 AM
try mustangs unlimited.
Winterpark SSP
11-01-2007, 08:08 AM
No luck at Mustangs Unlimited either. Fairly common for the lines to become brittle which surprises me with the number of 5.0 engines produced why for doesn't make the part.

Time to go to the "bone yard".

Thanks!

Barry