Quote:
Originally Posted by Vintageracer
The only CHP picture in the agency section shows a shelf for the radio equipment and siren amplifier. Does anyone have any pictures of where this equipment was direct mounted on boards to the sheetmetal floor under the package tray?
|
I take it these are questions concerning your '92 EVOC car. The standard for trunk mounting the radio/amp equipment was on a wood shelf supported by metal legs as shown on Jim Young's '92 CHP:
If this was the method used in your car, you should have four screw holes in the trunk floor for the shelf support legs. If that's not the case, there may have been some other way it was done just for your car and this is highly likely as yours was a special purpose vehicle and not a regular patrol unit. Finding hard documentation for your installation could be challenging...it's very, very tough to find trunk photos for just the regular Mustang units...I only seen a single in-service shot of one ever.