|
|
|||||||
| Special Service Mustang Parts For Sale Got SSP parts? Please post 'em. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#2
03-03-2010, 08:17 AM
|
||||
|
||||
looks good!
__________________
Mike 1992 Michigan State Police SSP Mustang #5114 1993 Wisconsin State Patrol SSP Mustang 1993 Missouri State Highway Patrol SSP Mustang P641 http://members.fotki.com/MOstang/ 
|
|
#4
03-03-2010, 11:33 AM
|
|||
|
|||
|
I had posted this once before a few years ago
it's the Wax on Wax off version of Valid plates on Valid plates off. behind the Valid plate i use the Fuzzy side of a Velcro adhesive so it will not scratch the novelty plate. roll up at car show, pop trunk Un-du 4 wing nuts pull magnetic strips off the decal area's of the car magic duster and your done. also..had the novelty plates made in Phoenix a few years ago. guy is not in business anymore?   
|
|
#5
03-03-2010, 04:51 PM
|
||||
|
||||
|
Andy - That's a great idea! I have been trying to think of an easier way to make the switch for car shows and it sounds like you have figured it out.
__________________
Mike 1992 Michigan State Police SSP Mustang #5114 1993 Wisconsin State Patrol SSP Mustang 1993 Missouri State Highway Patrol SSP Mustang P641 http://members.fotki.com/MOstang/
|
|
#6
03-03-2010, 08:57 PM
|
||||
|
||||
|
I also did the simular mounting by using 1/4" bolt 4" long cutting it in three so each bolt is abound 1 1/4" long. Usuing a acorn nut, I wrenched in so it stuck out enough to put a regular nut and washer to hold registration plate on tight. I cover the extender bolt with the acorn nut and snugged it to the regular nut lightly tightened so it looked nice and clean. When I put the display plate on, I just take off the acorn nut, mount the plate on the bolt and snugg up the acorn nut. It looks good from a short distance. Just a added thought for quick mounting display plates.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
