1993 SSP?

[86NeSSP]

1993 Ex highway patrol coupe. Most parts have less than 100 miles on them. My wife and I are in the process of adopting a baby, and the mustang is in the way of my welding in the garage, so it needs to go. This is a project, If I were to keep the car, I would put a roll cage, and an automatic in it, and with a good tune It would be a 10sec ride. There are many parts on the car , I will try and give a good rundown of them.

302 block machined for a 347 by ledfords in Waco. Block was bored and honed with torque plates, square decked, etc, and they assembled the longblock.

Powerhouse heads from enginekits.com 2:05/1:60 vavles
Probe -20cc dished pistons (forged)
Forged I-beam rods
New cast crank
Canton main support
Proform 7qt pan
Head studs
Cometic head gaskets
Cobra vavle covers
Polished cobra upper and lower
75 mm Trottlebody
C&L 76 mm mass air meter
Diablo chip
F-cam
5 speed (T-5)
Extra T-5 (no 5th gear)
42lb injectors
255lph intank pump
T-rex inline pump
3:73 gears
4 inch cowl hood
Welded subframes
70mm turbo kit from ponydown performance
24x3x12 innercooler
Tial 50mm blow off vavle
Tial 38mm wastgate
3 inch single exhaust, from turbo back,dumped

I'm sure there is more, please call (254) 258-4608

There is a small loan balance on the car, so I do NOT have title in hand. Does anyone have a nice Miller plasma cutter?? Thanks--








This still shows to have the supression straps for the hood...

Matt