|
|||||||
| Members' SSPs A place to post up pics of your SSP, whether restored, in-progress, or somewhere in-between. |
![]() |
|
|
Thread Tools | Display Modes |
|
|
|
#1
|
||||
|
||||
|
I've searched the Internet, there are two eBay listings, but they are the same seller and there is NO stock; the 10 available shown is an error. I've been in contact and they said they have been trying to take them down but eBay software keeps reposting. I have checked with Autoplicity, Summit Racing, Wrench Monkey, all of them. I even checked with the last manufacturer, ATP Automotive: nada.
I'm betting this is one of those parts that didn't fare well in service. Like most exhaust system components, over time rusted, seized up, and was removed completely or (like the ones I have) someone modified them by removing the butterfly valve and vacuum pot. In California, it will fail the smog check on a visual inspection just for that. This part was used on a lot of Ford and Mercury products 81-86. I may have to go to a junkyard, crawl under some hulk in a puddle of oil, transmission fluid, and general putrefaction, then wrestle with two rusted, baked on nuts to remove one that's probably seized up anyway or just worn out. Then I can take it back to my shop, polish it up, unstick the valve/shaft, then the smog checker will be happy because it's there. This is my last resort. I haven't gone to a junkyard for many years, but then I haven't gotten this deep into auto work since I was a teenager. Oh well, perhaps I can spin it into something good: Virtually going back in time and reliving youth...
__________________
******************************************* 1982 CHP 0327 |
|
#2
|
||||
|
||||
|
Steve is that a CA item only?
I have several early 5.0 motors that are complete with manifolds. I can check them to see if I have one on any of those motors.
__________________
Jim for the first time since 1998 there is only two left: 1984 Oregon SP unmarked 1986 Idaho SP |
|
#3
|
||||
|
||||
|
I think I have a couple extras also.
__________________
Mike '82 SSP (Marketing Order) '83 Colorado State Patrol #202 '83 Texas DPS '85 Florida Highway Patrol #1422 '93 Florida Highway Patrol #1187 '93 Florida Highway Patrol #1363 |
|
#4
|
||||
|
||||
|
I sure am in the market for one if you have one to sell. I found out today the company I ordered online from has no stock either and won't because the manufacturer has discontinued. These things are scarcer than hen's teeth, or a genuinely honest politician in Washington D.C.
__________________
******************************************* 1982 CHP 0327 |
|
#5
|
||||
|
||||
|
If I have an extra, you can have it. I will try to get over there this weekend and take a look.
__________________
Mike '82 SSP (Marketing Order) '83 Colorado State Patrol #202 '83 Texas DPS '85 Florida Highway Patrol #1422 '93 Florida Highway Patrol #1187 '93 Florida Highway Patrol #1363 |
|
#6
|
||||
|
||||
|
Steve,
Made it over there yesterday to check. I have extra manifolds, but not extra valves. Sorry about that. I was sure I had a box with extras.
__________________
Mike '82 SSP (Marketing Order) '83 Colorado State Patrol #202 '83 Texas DPS '85 Florida Highway Patrol #1422 '93 Florida Highway Patrol #1187 '93 Florida Highway Patrol #1363 |
|
#7
|
|||
|
|||
|
A member on FEP came through with one for the cost of shipping. Hopefully shipping out today.
|
|
#8
|
||||
|
||||
|
I don't know if it is CA only. It would be located at the end of the driver's side exhaust manifold, between the manifold and the exhaust pipe.
__________________
******************************************* 1982 CHP 0327 |
![]() |
| Thread Tools | |
| Display Modes | |
|
|