|
|
#1
03-09-2010, 10:40 AM
|
||||
|
||||
Header Removal
I'm going to replace the headers on my 89 this weekend and was wondering if there are any tips for loosening 21 year old header bolts without snapping them.
Thanks Gary
__________________
2003 AB Mach 1 
|
|
#2
03-09-2010, 11:26 AM
|
||||
|
||||
|
spray em down with "PB Blaster" and let them soak for about an hour prior to putting the wrench to them. They should come loose ok.
__________________
Jim 1982 CHP 1983 FHP 1984 Oregon State Police (dark blue unmarked) 1984 Oregon State Police (marked, consecutive vin) 1985 TXDPS 1986 Idaho State Police 1987 FHP 1988 Missouri State Highway Patrol 1989 Michigan State Police 1990 Colorado State Police 1991 GSP 1992 Michigan State Police 1993 FHP My cars. http://public.fotki.com/Nodrama/
|
|
#4
03-10-2010, 09:38 PM
|
||||
|
||||
|
Could have used some of that today at the junk yard. Didn't get what I wanted as it broke. Was rusted on pretty good.
__________________
Toshi '93 SSP '90 LX 'vert - Sold '87 LX hatch (parted out) '88 LX 'vert (should have never) '83 GL hatch (college car, long gone)
|
|
#5
03-13-2010, 12:16 PM
|
||||
|
||||
|
Headers
PB Blast the nite prior and let soak. Mine came right off
 Good Luck!
__________________
Barry "Future Is What Present Does"  Collectables: 1993 WinterPark FL SSP Unit 1017 (72K miles) Other(s): 1987 Buick Grand National (862 miles) 1989 Pontiac Turbo Trans Am- Pace Car (2,847 miles) 1990 Chevrolet Camaro IROC 5.7 "1LE" (COPO), 1 of 64 (28 with 5.7L) (10,111 miles) 1995 Corvette ZR1 (859 miles) "Kiddie Carrier" 2008 BMW M5 (500 HP, V10, 6-speed....sedan)
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
