1983 GSP Perm #3083

[ImEvil1]

Originally Posted by FoxChassis

They may have never been installed at the factory. Rocker mouldings were standard on all except the L trim level so if they were "deleted" per the special order I would think there would have been comments for such on the build sheet. I doubt there is a build sheet in that car now, if there ever was one, but you never know.

The moulding on each side was held on with clips and the clips were riveted to the rocker panel, so you should see small holes along the center horizontal plane of the rocker panel, unless either the car had them deleted at the factory or a prior owner took them off and filled the holes.

Both of my '83s (GLs) have them as well. Black in both cases. Plenty of them in the in-service '83 CSP and TX DPS pictures.

[kapracing]

Checked seat back for build sheet , no luck... Found this though. Anybody know what this is?

[FoxChassis]

I think that is the delivery sticker (from Ford Parts Dist. Center to Benny Jackson Ford) affixed to the driver side upper seat frame. 61019 is the basic part number for the seat frame.

[kapracing]

Originally Posted by FoxChassis

I think that is the delivery sticker (from Ford Parts Dist. Center to Benny Jackson Ford) affixed to the driver side upper seat frame. 61019 is the basic part number for the seat frame.

Thanks Mick.
Didn't know what it was lol

[kapracing]

Cleaned out trunk, trunk floor is VERY SOLID... No equipment holes unlike all my other GSP's. just the one antenna hole on top of passenger quarter ...

[kapracing]

Second floor pic

[1989 Tx DPS SSP]

Look behind the Drivers side rear trim panel for a Build Sheet.

Tom

[smunczen]

Lable from a part.